KSCUT-65A Multifunctional Metallographic specimens

1.Application:
This machine is used for cutting the metallographic specimens with irregular shapes such as cylinder, polygon etc., so as to observe the metallographic and lithofacies structure of the material.
The cooling system with good coolant can take away the heat of cutting so as to protect the structure of speciment from being burned. During cutting, the specimen can be adjusted in any angles, which helps to avoid the minor burning when the specimen is cut to fall. At the same time the cutting cross seciont is increased, thus the utilization ratio of curring sand wheel is imporived.

2.Technical Parameters:
Model: KSCUT-65A
Cutting Capacity Max. Dia: 65mm
Rotating Speed: 2800 rpm
Diameter Of Cutting Disc: 250*2*32 mm
Motor: 1.5 KW
Power Supply: Three Phases, 380V, 50Hz
Cutting modes: Manual